{"id":1762,"date":"2020-03-20T15:31:47","date_gmt":"2020-03-20T14:31:47","guid":{"rendered":"https:\/\/www.tspelettronica.com\/?p=1762"},"modified":"2021-06-12T18:07:23","modified_gmt":"2021-06-12T17:07:23","slug":"panadapter-sdr-per-ic-7700","status":"publish","type":"post","link":"https:\/\/www.tspelettronica.com\/en\/2020\/03\/20\/panadapter-sdr-per-ic-7700\/","title":{"rendered":"IC-7700 with SDR panadapter"},"content":{"rendered":"\n

Our buffer interface named IFace <\/a>can be used to add an SDR panadapter to the Icom IC-7700.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n

The operations to be performed are very simple, it is sufficient to obtain from its wiring diagram the information on the points where to take the IF signals.<\/p>\n\n\n\n

Testimonial by IU8JAD Pellegrino<\/strong><\/a><\/p>\n\n\n\n

This radio, in fact, uses different mixers. In particular, we will have to use the first of the RX chain. The following images show the block diagram of the radio. For the IC-7700 the first IF is shown in the small table in the following image.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n

We now proceed to identify the exact points on the printed circuit board where to take the IF signal to be sent to the IFace. The following images show the sampling point for the IF signal and for the power supply for the buffer interface.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n

In order to purchase an IFace please use the buttons below.<\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n
\n
\n
<\/div>\n