{"id":2312,"date":"2021-04-07T22:45:07","date_gmt":"2021-04-07T21:45:07","guid":{"rendered":"https:\/\/www.tspelettronica.com\/?p=2312"},"modified":"2021-06-12T14:30:45","modified_gmt":"2021-06-12T13:30:45","slug":"panadapter-sdr-per-ic-718","status":"publish","type":"post","link":"https:\/\/www.tspelettronica.com\/en\/2021\/04\/07\/panadapter-sdr-per-ic-718\/","title":{"rendered":"IC-718 with SDR panadapter"},"content":{"rendered":"\n

Our buffer interface named IFace <\/a>can be used to add an SDR panadapter to the Yaesu IC-718.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n

The operations to be carried out are very simple, it is sufficient to obtain from its wiring diagram the information on the points where the IF signal has to be taken. This radio uses several mixers and we are interested in the first IF frequency (this makes it easier to operate the panadapter). The IF frequency chosen is 64.455 MHz and our SDR panadapter will be tuned to this<\/strong>. The following image shows the block diagram of the radio and where to get the IF signal.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n

The following image shows the portions of the schematic diagram of the IF UNIT where we can see the exact points where to sample the IF signal and the power supply.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n

We now proceed to identify the exact points on the printed circuit board where to take the IF signal to be sent to the IFace. The following images show the sampling point for the IF signal and for the power supply for the buffer interface.<\/p>\n\n\n\n

\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n
\"\"<\/a><\/figure>\n\n\n\n

The use of PTT signal is not required because RX and TX signals are separated.<\/p>\n\n\n\n

In order to buy an IFace use the buttons below.<\/p>\n\n\n\n

\"\"<\/figure><\/div>\n\n\n\n
\n
\n
<\/div>\n