These are the instructions to install the IFace interface inside of the Kenwood TS-830s in order to add an SDR panadapter to the radio. The installation is very easy.
![IFace 2](https://www.tspelettronica.com/wp/wp-content/uploads/2020/06/Diapositiva12-1024x576.png)
On the upperside of the radio, after removing the cover, locate the electronic board called “RF Unit”: this is shown in the following picture.
![](https://www.tspelettronica.com/wp/wp-content/uploads/2021/09/Diapositiva17-1024x576.png)
Refer to the following images of the wiring diagram to identify the points where you can weld the cables for the IF, power supply and PTT.
![](https://www.tspelettronica.com/wp/wp-content/uploads/2021/09/Diapositiva16-1024x576.png)
![](https://www.tspelettronica.com/wp/wp-content/uploads/2021/09/Diapositiva18-1024x576.png)
Refer to the following image to identify the points on the PCB where to weld the various connecting cables.
![](https://www.tspelettronica.com/wp/wp-content/uploads/2021/09/Diapositiva19-1024x576.png)
In order to buy an IFace please use the following buttons.
![Paypal](https://www.tspelettronica.com/wp/wp-content/uploads/2020/06/Payment.png)
ATTENTION: Though installing the IFace is not difficult, you do this at your own risk. TSP S.r.l. is not responsible for any damage, unwanted side-effects or whatever.
For more information do not hesitate to write us.
Have fun!