fbpx

Panadapter SDR for the FT-757GX

Panadapter SDR for the FT-757GX

These are the instructions to install the IFace interface inside of the Yaesu FT-757GX in order to add an SDR panadapter to the radio. The installation is very easy.

IFace 2

After removing the cover, locate the electronic board called “RF UNIT”: the signal we are interested in are on this board.

Refer to the following image of the wiring diagram to identify the points where you can weld the cables for the IF and the power supply. The PTT+ is required, the signal paths for the RX and the TX are not completeley separated.

Refer to the following image to identify the points on the PCB where to weld the various connecting cables.

In order to buy an IFace please use the following buttons.

Paypal

ATTENTION: Though installing the IFace is not difficult, you do this at your own risk. TSP S.r.l. is not responsible for any damage, unwanted side-effects or whatever.

For more information do not hesitate to write us.
Have fun!

admin

    You must be logged in to post a comment