These are the instructions to install the IFace interface inside of the Kenwood TS-530s. The installation is very easy.

- On the upperside of the radio, after removing the cover, locate the electronic board called “IF Unit”: this is shown in the following picture. In the same you can also see where you can mount the IFace
with simple double-sided adhesive tape.

- Refer to the following images of the wiring diagram to identify the points where you can weld the cables for the IF, power supply and PTT.


- Refer to the following image to identify the points on the PCB where to weld the various connecting cables.


- Finally connect the coaxial output cable of the IF signal and pass it through the ventilation holes of the radio as shown in the picture.


ATTENTION: Though installing the IFace is not difficult, you do this at your own risk. TSP S.r.l. is not responsible for any damage, unwanted side-effects or whatever.
For more information do not hesitate to write us.
Have fun!